Panasonic DMRES35V Guida Al Funzionamento

Pagina di 76
17
RQTV0136
Recording television programmes
[1]
Press [
<, OPEN/CLOSE] on the main unit to open 
the tray.
≥You can insert a cartridge or non-cartridge disc.
[2]
Press [
<, OPEN/CLOSE] on the main unit to close 
the tray.
≥If you insert a DVD-RAM with the write-protect tab set to “PROTECT” 
l 55), play starts automatically.
Notes
≥A double-sided disc should be loaded with the side you want to record/
play facing down.
≥It is not possible to record continuously from one side of a double-sided 
disc to the other. You will need to eject the disc and turn it over.
≥When using 8 cm DVD-RAM or 8 cm DVD-R, remove the disc from the 
cartridge.
The surface on which you can 
see a roll of tape should face 
up. 
Insert a video cassette.
≥The unit is automatically turned 
on.
≥Play starts automatically if you 
insert a video cassette without 
the accidental erasure 
prevention tab.
∫ To eject a video cassette
≥You can eject a video cassette even when the unit is in standby mode. It 
switches back to standby once it ejects the video cassette.
For main unit
≥Press [<, EJECT] on the main unit.
For remote control
≥Press [DRIVE SELECT] to select the VHS and then press and hold
[
∫, STOP] for about 3 seconds or more.
[+RW]
≥The created title menu is deleted when recording on the disc.
Create the title menu again by using “Create Top Menu” in DVD 
Management
. (
[VHS]
Video cassette care
≥Poor quality or damaged video cassettes can cause the heads to 
become dirty and malfunction. Store your video cassettes carefully and 
discard them when they become dirty or damaged. 
≥Never use video cassettes on which juice has been spilled or those that 
are extremely damaged since this will not only cause the heads to 
become dirty, but will also make the unit malfunction. 
Video cassette maintenance
Cleaning the video heads
Dirt on the video heads can cause poor recording and play. 
≥If the picture does not improve, use an optional head-cleaning cassette. 
If the problem persists seek advice from a qualified service personnel. 
[DVD]
Finalize (
l 56) the disc to make it playable on other equipment or set the 
protection (
l 55) so that you do not accidentally erase the contents. 
[VHS]
≥Break off the video cassette’s tab to 
prevent accidental erasure. Cover the 
hole with a double layer of adhesive tape 
when you want to use the video cassette 
for recording again. 
≥You can use video cassettes with the 
VHS and S-VHS marks, but the unit is unable to make full use of the 
characteristics of S-VHS video cassettes.
Inserting a disc
Inserting a video cassette
(2)
(3)
(1)
Non-cartridge disc
Cartridge disc
(1) Insert label-up.
(2) Insert fully so it clicks into place.
(3) Insert label-up with the arrow facing in.
Before recording
After recording
Tab
Recording
RQTV0136.book  17 ページ  2006年4月19日 水曜日 午後1時28分