Panasonic KXMB781 Guida Al Funzionamento

Pagina di 96
11. Help
71
For assistance, please visit http://www.panasonic.com/help
11.3.6 Network (KX-MB781 only)
Problem
Cause & Solution
I cannot operate the following 
functions.
PC printing
Scanning
Remote Control
PC FAX
Device Monitor
L
Confirm the LED via the LAN port of the main board. If the LED is glowing 
or blinking red, the network access is working correctly.
If the LED is not glowing or blinking, confirm the LAN cable (category 5 
straight cable) is connected to the LAN port of the main board correctly.
L
If the LED is blinking and you cannot perform the desired operation, the IP 
address of the unit may have changed.
To detect the IP address, proceed as follows.
[
Start] i [All Programs] or [Programs] i [Panasonic] i the 
unit’s name i [IP Address Checker].
L
The IP address for the unit will be detected.
Note:
L
If the IP address cannot be detected, enter it manually (feature #501 on 
page 57). The IP address of the computer and the unit must be in the 
same local IP address class as shown below. Set the IP address in the 
range of the number specified in the class corresponding to your local 
network scale.
Class
Subnet mask
IP address
Class A
255.0.0.0
10.0.0.1 -
10.255.255.254
Class B
255.255.0.0
172.xx.0.1 -
172.xx.255.254
Class C
255.255.255.0
192.168.xx.1 -
192.168.xx.254
*1 “xx” should be the same value for the unit and for the computer, as 
shown in the following example.
Example: 172.16.0.1 - 172.16.255.254
(The available range of “xx” is 16 - 31)
*2 “xx” should be the same value for the unit and for the computer, as 
shown in the following example.
Example: 192.168.0.1 - 192.168.0.254
(The available range of “xx” is 0 - 255)
L
Your firewall software is blocking the connection. Disable the firewall 
software or change the firewall settings to make the Multi-Function Station 
work properly.
The unit does not appear in 
the 
[Select a Network Device] 
dialog box when installing 
Multi-Function Station.
L
Your firewall software is blocking the connection and the setup program may 
not list any units. Consult your network administrator and temporarily 
disable the firewall software.