Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Guida Specifiche
8
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
OL-5788-01
Configuring the Router
Initial Configuration Using the Cisco CLI—Manual Configuration
This section shows how to display a command-line interface (CLI) prompt for configuration using the
CLI, and it directs you to documentation for the CLI configuration.You can use the CLI if you see the
following messages at the end of the startup sequence:
CLI, and it directs you to documentation for the CLI configuration.You can use the CLI if you see the
following messages at the end of the startup sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file were installed on the router at the
factory. To use SDM to configure your router, see the
factory. To use SDM to configure your router, see the
.
For help with interface and port numbering, refer to the
section of the “
online document.
Step 1
To proceed with manual configuration using the CLI, enter no when the power-up messages end:
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to terminate autoinstall and continue with manual configuration:
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Step 3
Press Return to bring up the Router> prompt.
...
flashfs[4]: Initialization complete.
Router>
Step 4
Type enable to enter privileged EXEC mode:
Router> enable
Router#
Step 5
For configuration procedures, refer to the online
documents.
Note
To avoid losing work you have completed, be sure to save your configuration occasionally as
you proceed. Use the copy running-config startup-config command to save the configuration
to NVRAM.
you proceed. Use the copy running-config startup-config command to save the configuration
to NVRAM.
Step 6
When you have finished the initial configuration, verify the initial configuration. See the
for verification procedures.