Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY 사양 가이드

This section shows how to display a command-line interface (CLI) prompt for configuration using the 
CLI, and it directs you to documentation for the CLI configuration.You can use the CLI if you see the 
following messages at the end of the startup sequence:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

If these messages do not appear, SDM and a default configuration file were installed on the router at the 
factory. To use SDM to configure your router, see the 

.

For help with interface and port numbering, refer to the 

 section of the “

of Cisco 2800 Series Routers” 

online document.

To proceed with manual configuration using the CLI, enter no when the power-up messages end:

Would you like to enter the initial configuration dialog? [yes/no]: no

Press Return to terminate autoinstall and continue with manual configuration:

Would you like to terminate autoinstall? [yes] Return

Several messages are displayed, ending with a line similar to the following:

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled <date> <time> by <person>

Press Return to bring up the Router> prompt.

flashfs[4]: Initialization complete.

Router>

Type enable to enter privileged EXEC mode:

Router> enable 

Router#

For configuration procedures, refer to the online 

 documents.

To avoid losing work you have completed, be sure to save your configuration occasionally as 
you proceed. Use the copy running-config startup-config command to save the configuration 
to NVRAM.

When you have finished the initial configuration, verify the initial configuration. See the 

 for verification procedures.