Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16 Guida Specifiche

See the following sections for the configuration tasks required to run the RPR/RPR+, SSO with NSF,
FSU, and SLCR features:

 (required)

 (optional)

 (optional; but SSO required)

 (optional)

To enter privileged EXEC configuration mode, enable the router using the following steps:

At the user-level EXEC prompt, run the enable command. The router prompts you for a privileged-level
password as follows:

Router> enable

Password:

Type the password (the password is case sensitive). For security purposes, the password is not displayed.

When you specify the correct password, the system displays the privileged-level system prompt (#):

Router#

This completes the procedure for enabling the router.

You can use TFTP to copy a high availability Cisco IOS software image onto the active and standby
RSPs.

Before you begin to copy a file to a Flash Disk, be sure that there is enough space available in Flash
memory. To verify the amount of Flash memory available, you can use the show flash: command.
Compare the size of the file you are copying to the amount of available Flash memory shown. If the space
available is less than the space required by the file you will copy, the copy process will continue, but the
entire file will not be copied onto the Flash Disk.