Cisco 7000 SERIES PA 8 PORT T1 MC ADAPTER WITH CSU DSU Guida Specifiche
C H A P T E R
2-1
Multichannel DS1/PRI Port Adapter Installation and Configuration
OL-3525-03
2
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing
multichannel DS1/PRI port adapters. The chapter contains the following sections:
multichannel DS1/PRI port adapters. The chapter contains the following sections:
•
•
•
•
•
Required Tools and Equipment
You need the following tools and parts to install a multichannel DS1/PRI port adapter. If you need
additional equipment, contact a service representative for ordering information.
additional equipment, contact a service representative for ordering information.
•
PA-MC-2T1(=), PA-MC-4T1(=), PA-MC-8T1(=), or PA-MC-8DSX1(=)
•
Catalyst RSM/VIP2 (for installation in the Catalyst 5000 family switches). For information about
the specific VIP2 models that support the multichannel DS1/PRI, see the
the specific VIP2 models that support the multichannel DS1/PRI, see the
.
•
Catalyst 6000 family FlexWAN module (for installation in the Catalyst 6000 family switches).
•
Cisco 7304 PCI Port Adapter Carrier Card (for installation in a Cisco 7304 router).
•
Versatile Interface Processor (VIP) (for installation in Cisco 7000 series or Cisco 7500 series
chassis only).
chassis only).
•
Category 3 or 5 UTP RJ-48C interface cables to connect the multichannel DS1/PRI port adapter and
CSU.
CSU.
•
T1 CSU to connect the multichannel DS1/PRI port adapter (PA-8DSX1 version only) with the
wide-area network.
wide-area network.
•
Number 1 Phillips and a 3/16-inch flat-blade screwdriver (for VIP installation only).
•
Number 2 Phillips screwdriver.
•
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares.
strap included with all upgrade kits, field-replaceable units (FRUs), and spares.
•
Antistatic mat.
•
Antistatic container.