Sensaphone Sentinel SCD-1200 Manuale Proprietario
10
Sentinel Installation and Setup Guide
INSTALLATION AND CONFIGURATION
PHYSICAL DESCRIPTION
The Sentinel is housed in a 5.5” x 5.5” x 1.5” enclosure, which can be easily wall mounted.
LAYOUT
The Sentinel has connections for twelve sensor inputs, an ethernet port, and 12VDC power. See figure
below:
The Sentinel has connections for twelve sensor inputs, an ethernet port, and 12VDC power. See figure
below:
Figure 1: Front Panel Layout of the Sentinel
1) Acknowledge/Standby Button
5) Power Jack
2) On/Off Switch
6) Ethernet Jack
3) Power, Online, Standby LEDs
7) Sensor Input Terminal Strip
4) Alarm LEDs
8) Relay Output Input
RJ-45 10/100BASE-T ETHERNET PORT
This jack is for connecting to your network so that the device can communicate with the Sentinel serv-
ers. Two LEDs indicate when the Sentinel has a valid link (green) and transmitted/received data (yel-
low).
This jack is for connecting to your network so that the device can communicate with the Sentinel serv-
ers. Two LEDs indicate when the Sentinel has a valid link (green) and transmitted/received data (yel-
low).
SENSOR INPUTS
The sensor inputs labeled zones 1-12 are designed to interface with normally open/normally closed
devices, 2.8K or 10K temperature sensors and 4-20mA transducers.
The sensor inputs labeled zones 1-12 are designed to interface with normally open/normally closed
devices, 2.8K or 10K temperature sensors and 4-20mA transducers.
POWER ON LED (GREEN)
This light indicates that the Sentinel unit is powered and operational.
ALARM LEDS (RED)
The Alarm LEDs indicate if an alarm exists.
ONLINE LED (GREEN)
This light indicates that the Sentinel unit is communicating with the Sentinel servers.
STANDBY LED (YELLOW)
This light indicates that the Sentinel unit is in standby mode.