Sensaphone Sentinel SCD-1200 Manuale Proprietario

11

Chapter 1: Installation

ACKNOWLEDGE/ STANDBY BUTTON
When an unacknowledged alarm exists (as indicated by a blinking red alarm LED), briefly press the but-
ton and the alarm LED will stop blinking, indicating that the alarm is acknowledged. To enter Standby 
mode, press and hold the button for at least 5 seconds until the Standby LED lights up, then release. To 
exit from Standby mode, hold the button down for 5 seconds until the Standby LED turns off.   

This section provides information on:

t0QFSBUJOHFOWJSPONFOU
t*OTUBMMBUJPO
t$POOFDUJOHTFOTPST
t/FUXPSL$POGJHVSBUJPO

PARTS REQUIRED
t4DSFXESJWFSBOETDSFXT

t/FUXPSL)VC 4XJUDI PS3PVUFSUIBUTVQQPSUTPS#"4&5

t$PNQVUFSX*OUFSOFU$POOFDUJPO

Before you install the Sentinel be sure that your operating environment meets the physical requirements 
of the equipment.

Operating Temperature:   

32º – 122º Fahrenheit (0º – 50º C)

)VNJEJUZ

o3) OPODPOEFOTJOH

1PXFS

7"$)[PVUMFUXJUIJO

Connect the included AC power supply to the power jack on the Sentinel. Plug the power adapter into a 
115V AC power outlet. 

Using the included network cable, connect the Sentinel into your network hub, switch or router. If your 
OFUXPSLTVQQPSUT%)$1UIF0/-*/&HSFFO-&%TIPVMEMJHIUVQXJUIJOBGFXNJOVUFTJOEJDBUJOHUIBU
the device has connected to the sensaphone.net servers.

If your network requires the device to have a static IP address, please contact Sensaphone technical sup-
port for availability of this feature.