Wet Sounds STX Micro 4 Manuale Proprietario
FEATURES AND CONTROLS – STX MICRO-4
4
The STX MICRO-4 is an 80-watt four channel full range class D amplifier.
This versatile amp may be used to drive 2 or 4 full range channels, or the
front channel outputs for full range speakers and the rear channel outputs
for subwoofers, or any combination of these.
This versatile amp may be used to drive 2 or 4 full range channels, or the
front channel outputs for full range speakers and the rear channel outputs
for subwoofers, or any combination of these.
1. Crossover Controls HPF. The High Pass Filter sets the upper frequency
range for that channel. When the High Pass Filter is set to 800 Hz, that
channel will pass all frequencies 800Hz and above.
channel will pass all frequencies 800Hz and above.
2. Crossover Control FLAT. This will disable the crossover – allow all
frequencies to pass.
3. Crossover Control LPF. The Low Pass Filter sets the lower frequency range
for that channel. When the Low Pass Filter is set to 80Hz, that channel will
pass all frequencies 80Hz and below.
pass all frequencies 80Hz and below.
4. Sensitivity. This control is used to match the input of the amplifier to
the source unit. The higher the sensitivity the sooner the amp will reach
maximum output.
maximum output.
5. Frequency Controls. These are used to select the frequency for the
Crossover Controls.
6. Channel Select. In 2 channel mode, all 4 speakers will play using only the
FRONT input. In 4 channel mode – front and rear speakers are independent
and must receive both a FRONT and REAR input. When using the STX
MICRO-4 in Bridged Mode this switch should be in the “2CH” position.
and must receive both a FRONT and REAR input. When using the STX
MICRO-4 in Bridged Mode this switch should be in the “2CH” position.
7. Power/Protect Indicator. This indicator will light up RED upon initial amp
start up. If all connections are OK, within 3-5 seconds the light will turn to
BLUE. If a condition of protect (short circuit, over/under voltage) occurs the
light will turn to RED until the condition of protect is resolved.
BLUE. If a condition of protect (short circuit, over/under voltage) occurs the
light will turn to RED until the condition of protect is resolved.
:HW6RXQGV67;0,&526HULHV$PSOL¿HUV
Operations / Installation Manual