Brandmotion 9002-8847 Manuale Proprietario

2632 Instructions 2-24-15.docx 

Page 2 of 3 

Step 1: Use a Plastic Trim Removal Tool to remove 
console and dash trim pieces to gain access to the 
radio bezel. 

Step 2: Use a Plastic Trim Removal Tool to remove 
radio bezel. 

Step 3: Unplug all radio connectors from the radio 
head unit and set radio aside. 

Step 4: Insert terminal from red wire on supplied 
jumper harness into position 31 of black 52-pin 
radio connector and insert terminal from black wire 
on supplied chassis harness into position 32 of 
black 52-pin radio connector.

 

Step 5: Connect male RCA of camera into female 
RCA of jumper harness and proceed to the Dealer 
Programming Instructions (Included). 

 

Continue with steps 6 through 9 for vehicles 
with 22-pin radio connector. 

IMPORTANT: If the White 22-pin connector is 
present in the vehicle and Pin 3 and/or Pin 4 are 
already populated, remove the terminal(s) using 
Delphi Terminal Removal Tool #12094429 or a 
Small Flat Watch Repair Screwdriver and isolate 
with Electrical Tape. 

Step 6: Remove both terminals from chassis 
harness. Splice provided loose red wire to chassis 
harness red wire and insert terminal into pin 
position 3 on the white 22-pin radio connector 
(Figure 1) until it clicks securely. 

Step 7: Splice provided loose black wire to chassis 
harness black wire and insert terminal into pin 
position 4 on the white 22-pin radio connector 
(Figure 1) until it clicks securely. 

Step 8: Connect White 22-pin Connector to radio 
along with all remaining radio connectors before 
reinstalling radio head unit and all trim removed. 

Step 9: Connect male RCA of camera into female 
RCA of jumper harness and proceed to the Dealer 
Programming Instructions (Included).