Comp X Security Products Inc 421860 Manuale Utente
NOTE
Make sure strap is inside compartment under battery. The strap
handle should remain outside the compartment.
handle should remain outside the compartment.
1.
See Figure 68. Place the fully charged battery into com-
partment with terminals toward the front of the vehicle.
Lay strap handle over top of battery.
partment with terminals toward the front of the vehicle.
Lay strap handle over top of battery.
Do not over-tighten bolts on battery terminals. Use recom-
mended torque values. Over-tightening battery terminal
bolts could result in damage to battery terminals. (00216a)
mended torque values. Over-tightening battery terminal
bolts could result in damage to battery terminals. (00216a)
2.
Insert bolt through battery positive cable (+) (red) into
threaded hole of battery positive (+) terminal.
threaded hole of battery positive (+) terminal.
3.
Tighten bolt to 60-96 in-lbs (6.8-10.8 Nm).
4.
Insert bolt through battery negative cable (black) into
threaded hole of battery negative (-) terminal.
threaded hole of battery negative (-) terminal.
5.
Tighten bolt to 60-96 in-lbs (6.8-10.8 Nm).
Keep battery clean and lightly coat terminals with
petroleum jelly to prevent corrosion. Failure to do so could
result in damage to battery terminals. (00217a)
petroleum jelly to prevent corrosion. Failure to do so could
result in damage to battery terminals. (00217a)
6.
Apply a light coat of petroleum jelly or corrosion retardant
material to both battery terminals.
material to both battery terminals.
7.
See Figure 67. Install ECM caddy over battery compart-
ment. Tighten fastener to 15-20 ft-lbs (20-27 Nm).
ment. Tighten fastener to 15-20 ft-lbs (20-27 Nm).
8.
Align ECM with latches on caddy. Snap ECM into place
and slide to left side of vehicle until ECM rests against
bracket on left side of caddy and rests on guide pins. The
negative battery terminal should be visible through the
caddy.
and slide to left side of vehicle until ECM rests against
bracket on left side of caddy and rests on guide pins. The
negative battery terminal should be visible through the
caddy.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
9.
Install seat.
180 Maintenance and Lubrication