Exegin Technologies Limited Q52 Manuale Utente
61
Q52 Installation and Configuration Guide © Exegin Technologies Limited, 2007
8. Reference Information
Complete Command Reference
Complete Command Reference
Set commands
These commands alter the current or working settings in memory only. They will be lost
if the Q52 is turned off then on. To ensure this does not happen, be sure to issue a "
if the Q52 is turned off then on. To ensure this does not happen, be sure to issue a "
save
"
command so the current settings get written to Flash.
list [default|stored] radio
Lists the version, model number, RF
channel and receiver state for each Zigbee
radio in the Q52.
channel and receiver state for each Zigbee
radio in the Q52.
list [default|stored] snmp
List SNMP configuration.
list [default|stored] sysinfo
List the current Q52 system information
(e.g. contact name and protocol stacks
enabled).
(e.g. contact name and protocol stacks
enabled).
list [default|stored] user
List the current user definitions (e.g. user
names and types).
names and types).
list uptime
List the time the unit has been powered up
since the last power cycle. (e.g. "Uptime: 12
days, 22:50:23").
since the last power cycle. (e.g. "Uptime: 12
days, 22:50:23").
list [default|stored] zbmac
List all current Zigbee settings (e.g. RF
channel selections, PAN ID filter and
Extended Address Filters).
channel selections, PAN ID filter and
Extended Address Filters).
list zbnwk
Displays the current Zigbee network status,
including the MAC address, PAN ID,
Network Neighbour Table and Network
Routing Table.
including the MAC address, PAN ID,
Network Neighbour Table and Network
Routing Table.
list zbnwktest
Displays whether the Zigbee network test is
currently running, along with the test
results.
currently running, along with the test
results.
list zipt
Displays the host names of the remote
Zigbee bridge devices, as well as the UDP
port number used to transport Zigbee
messages over the IP network.
Zigbee bridge devices, as well as the UDP
port number used to transport Zigbee
messages over the IP network.
Table 5—Set Command Options
Command Syntax
Description
set sysinfo contact
contactname
Set a person or department to contact in case
of Zigbee bridge device trouble.
of Zigbee bridge device trouble.
For example:
set sysinfo contact
Christopher_Owen
Table 4—List Command Options
Command Syntax
Description