TTE Technology L42FHDE30 Manuale Utente

Other Information

You can’t select a certain channel.

• The channel may be blocked or not approved in the

Parental Control Menu.

• If using a VCR, check to make sure the

TV/VCR button on the VCR is in the correct mode (press the TV/

VCR button on your VCR).

• Press the

TV button and then try to change channels.

The stereo reception is noisy.

• It may be a weak station. Use the Sound Menu and Analog TV Sound to choose mono.

A black box appears on the screen.

• Closed captioning might be on. Check Closed Caption in the Setup menu.

You are having problems with the HDMI Connection.

• Make sure the HDMI or DVI component is turned on and the cables are firmly connected. If problems still

occur, turn off your component and reconnect it. Reset the power by unplugging the power cord and

plugging it back in.

• If you are tuned to the

HDMI 1, or other HDMI INPUT and you’re receiving Unusable Signal message

screen, press the

INFO button on the remote. If Acquiring Channel appears in the Channel Banner, the

HDMI or DVI device isn’t responding. Contact the manufacturer of the HDMI or DVI device for further

assistance.

• If you tune to the

HDMI 1, or other HDMI INPUT and you see snow, the video goes in and out, or the

video takes a long time to appear, your HDMI or DVI component is having trouble sending video

information to the TV. Reconnect your device. Reset the power by unplugging the power cord and plugging

it back in. If problems persist, try connecting the Y Pb Pr jacks if they are available or contact the

manufacturer of the HDMI or DVI component for further assistance.

• If you have black bars on each side of your picture, the component you connected might have a switch or

a menu

option allowing you to change the picture quality output that will fix this. Choose either 720p or 1080i.

The remote control doesn’t work.

• Something might be between the remote and the remote light sensor on the front of the TV. Make sure

there is a clear path.

• The remote may not be aimed directly at the TV.

• The batteries in the remote may be weak, dead, or installed incorrectly. Put new batteries in the remote.

The Universal Remote control doesn’t work.

This TV utilizes new remote control signals and may not be compatible with your existing universal remote (e.g.

satellite box remotes, cable box remotes, and generic universal remotes, etc.). Over time, newer universal

remotes will become available that should pick up the new TV codes.

You are experiencing problems with V-Chip/Parental Controls.

f the rating limits don’t work, you must lock the settings. Go to the Main Menu (press MENU on your remote),

select

Parental Control > V-Chip > Rating Enable, Rating Enable is highlighted. Press ◄/► to select On to

have the rating limits take effect.

What else can I do?

If you’ve been through the Troubleshooting section and nothing has fixed your problem, try rebooting your

TV. Note that after a reboot, you may need to run your TV through the setup process again. To do a reboot,

unplug the power cord from the wall outlet or power strip. Keep your TV unplugged for about 5 minutes. Then

plug in the TV and turn it on. See if the problem is fixed. If the problem remains, then please visit www.tclusa.

com for updated FAQs or contact TCL Customer Support at the support number provided in your Warranty

under “How To Get Service.”