System Planning Corporation GTLITEV3 Manuale Utente
GlobalTrak ™
GT Lite Operation and Maintenance Manual
4.1 Install GT Lite USB Drivers
The first step in connecting a GT Lite device to a PC Host is to install and configure the GT Lite
USB drivers. This step must be completed once for each GT Lite device connected to a PC.
Once the driver is installed for a GT Lite device, that device can be reconnected to the PC
Once the driver is installed for a GT Lite device, that device can be reconnected to the PC
without needing to reinstall the driver.
Install USB Driver
1. Connect GT Lite to a USB port with the GT Lite diagnostic cable.
2. Power on the GT Lite
3. Windows should recognize the new device
4. In the found new hardware wizard, select Install From a Specific Location and click Next
5. Select the location of Wavecom drivers and click OK.
Configure USB Driver
6. When installation is complete, open the Device Manager
7. Expand the Modems heading
8. Right click Wavecom USB Modem and click Properties
9. Open the Advanced tab and click Advanced Port Settings…
10. Set the Com Port Number that is not “In Use”. This should be the same com port number
for all GT Lite devices. After the first GT Lite is set up, Windows will warn that the COM
port is “In Use”. This is not a problem.
11. The other settings should look like the following:
Prepared: R. Straz
Date: July 25, 2007
Page 52 of
139