System Planning Corporation GTLITEV3 Manuale Utente
GlobalTrak ™
GT Lite Operation and Maintenance Manual
Expected Response:
APPLICATION: (SYSSTAT_ParamCommandHandler) Enter.
+SYSSTAT: ZIGMESH=<mesh>
OK
OK
<mesh>:
ZigBee mesh timeout in seconds
Set ZigBee Mesh Timeout
Set a new ZigBee mesh timeout.
Command:
AT+PARAM=”ZIGMESH”,”<mesh>”
<mesh>:
ZigBee mesh timeout in seconds
Expected Response:
OK
Programming Commands
Main Processor Upgrade
Upgrade the main processor by downloading a binary image from an FTP site and loading new
code.
Command:
AT+OTAU="[FTP Address and path]/[Filename],[Username],[Password]"
[FTP Address and Path]: FTP address and path to folder in which GT Lite code is
located.
located.
[Filename]: Filename for main processor code. Must have the extension of .wpd.dwl.
[Username]: Username required to access FTP.
[Username]: Username required to access FTP.
[Password]: Password required to access FTP.
Expected Response:
OK
Low Power Controller Upgrade
Upgrade the low processor controller by downloading a binary image from an FTP site and
loading new code.
loading new code.
Command:
AT+OTAU="[FTP Address and path]/[Filename],[Username],[Password]"
[FTP Address and Path]: FTP address and path to folder in which GT Lite code is
located.
located.
[Filename]: Filename for main processor code. Must have the extension of .ebl.
[Username]: Username required to access FTP.
[Username]: Username required to access FTP.
Prepared: R. Straz
Date: July 25, 2007
Page 86 of
139