Essence Security International ltd. ES6500EGE Manuale Utente
Operation
20
EverGuard Express
beep is sounded.
4. Using the number keys, enter the number of a key (1 – 0). The Status LED
flashes green and one good beep is sounded.
5. Enter the telephone number you want to store. Press the Status button.
Three beeps confirm that the number is defined. Programming mode
automatically ends and the status LED turns off.
automatically ends and the status LED turns off.
To delete the incoming telephone numbers:
1. Insert the Programming tool point into the Programming button. The Status
LED flashes red and one good beep sounds.
2. Using the number keys, enter the master PIN code. The Status LED flashes
green and one good beep is sounded. Programming mode is initiated.
3. Using the number keys, press 09. The Status LED flashes green and one good
beep is sounded.
4. To confirm the delete, press 09 again. Three beeps confirm that the number
is deleted. Programming mode automatically ends and the status LED turns
off.
off.
3.11 Defining Telephone Numbers for Outgoing
Calls
You can define up to nine numbers that are to be used for outgoing calls from the
EverGuard Express panel.
EverGuard Express panel.
Note: Number key 1 is predefined for the local emergency number.
For information on making a telephone call from the EverGuard Express panel,
refer to Making a Telephone Call on page 31.
refer to Making a Telephone Call on page 31.
To add or modify the telephone numbers for outgoing calls:
1. Insert the Programming tool point into the Programming button. The Status
LED flashes red and one good beep sounds.
2. Using the number keys, enter the master PIN code. The Status LED flashes
green and one good beep is sounded. Programming mode is initiated.
3. Using the number keys, press 10. The Status LED flashes green and one good
beep is sounded.
4. Using the number keys, enter the number of a key (2 to 0). The Status LED
flashes green and one good beep is sounded.
5. Enter the telephone number you want to store. Press the Status button.
Three beeps confirm that the number is defined. Programming mode
automatically ends and the status LED turns off.
automatically ends and the status LED turns off.
To delete the outgoing telephone numbers:
1. Insert the Programming tool point into the Programming button. The Status
LED flashes red and one good beep sounds.