BMI Technologies Inc. RFVI-II Manuale Utente
G FORCE PLUS RF Vehicle Monitor Installation Instructions
7
June/07
Yellow wires/Auxiliary Horn:
Connect one yellow wire to one of the two Auxiliary
Horn terminals labelled “SW”. Connect the second
yellow wire to the second Auxiliary Horn “SW”
terminal. Use a suitable length of red wire to make a
connection between the positive terminal on the
Auxiliary Horn (labelled “+”) and battery positive. An
unused portion of red battery positive wire from the
Wiring Harness may be used. Similarly, use a suitable
length of black wire to make a connection between the
negative terminal on the Auxiliary Horn (labelled “–”)
and battery negative. An unused portion of black battery
negative wire from the Wiring Harness may be used.
Horn terminals labelled “SW”. Connect the second
yellow wire to the second Auxiliary Horn “SW”
terminal. Use a suitable length of red wire to make a
connection between the positive terminal on the
Auxiliary Horn (labelled “+”) and battery positive. An
unused portion of red battery positive wire from the
Wiring Harness may be used. Similarly, use a suitable
length of black wire to make a connection between the
negative terminal on the Auxiliary Horn (labelled “–”)
and battery negative. An unused portion of black battery
negative wire from the Wiring Harness may be used.
White wires/digital sense input:
These wires are used to detect vehicle motion or lift
operation. For customized help with your particular
installation, contact Technical Assistance at BMI
Technologies Inc. at 1-800-563-8867.
operation. For customized help with your particular
installation, contact Technical Assistance at BMI
Technologies Inc. at 1-800-563-8867.
Blue wires/lift interrupt:
Use these wires to interrupt the lift solenoid on battery-
powered vehicles if desired. The contact on the blue
wires is fused at 3 amps – do not create a circuit that
exceeds this rating. Remove one vehicle wire at the coil
of the lift solenoid. Splice one blue wire to the wire just
removed. Connect the other blue wire to the vehicle lift
solenoid terminal. Tie these wires back if they are not
used, or if this is an internal-combustion vehicle
installation.
powered vehicles if desired. The contact on the blue
wires is fused at 3 amps – do not create a circuit that
exceeds this rating. Remove one vehicle wire at the coil
of the lift solenoid. Splice one blue wire to the wire just
removed. Connect the other blue wire to the vehicle lift
solenoid terminal. Tie these wires back if they are not
used, or if this is an internal-combustion vehicle
installation.