The Bodine Company FEBNET02 Manuale Utente
STEP #1
INSTALLING THE EMERGENCY BALLAST
> Disconnect AC power from the fixture. Remove the ballast channel cover and install the emergency
ballast either in the ballast channel or on top of the fixture.*
> Depending on the type of fixture in use install emergency ballast using one of the methods
illustrated below.
*
For installation on top of the fixture, wire bundle covers (RMC-LP) may be required by state or local codes. These covers are available from the
manufacturer as an accessory kit and must be ordered separately. Call your local distributor or the factory for complete information.
manufacturer as an accessory kit and must be ordered separately. Call your local distributor or the factory for complete information.
Inside Ballast Channel
Inside Strip Fixture
On Top of Fixture
WARNING:
TO PREVENT HIGH VOLTAGE FROM BEING PRESENT ON RED &
YELLOW OUTPUT LEADS PRIOR TO INSTALLATION, INVERTER CONNECTOR MUST
BE OPEN. DO NOT JOIN INVERTER CONNECTOR UNTIL INSTALLATION ISCOMPLETE
AND AC POWER IS SUPPLIED TO THE EMERGENCY BALLAST.
BE OPEN. DO NOT JOIN INVERTER CONNECTOR UNTIL INSTALLATION ISCOMPLETE
AND AC POWER IS SUPPLIED TO THE EMERGENCY BALLAST.
STEP #2
INSTALLING THE TEST SWITCH
> Refer to the illustrations above and install the test switch
through the ballast channel cover of a troffer or through the
side of a strip fixture.
> Drill a 1/2" hole and install the switch as shown.
> Wire the test switch so that it removes AC power from both
the emergency ballast (see wiring diagrams).
INSTALLATION
NOTE:
Make sure that the necessary branch circuit wiring is available. An unswitched source of
power is required. The emergency ballast must be fed from the same branch circuit as the
AC ballast.
power is required. The emergency ballast must be fed from the same branch circuit as the
AC ballast.
STEP #3
INSTALLING THE CHARGING INDICATOR LIGHT
> Install the CHARGING INDICATOR LIGHT as shown in the illustration on the following page so that it will be visible
after the fixture is installed.
Fixture
Test Button
Hex Nut
Hex Nut
Test Switch
Leads
Push to Test
Antenna Orientation Inside Ballast Channel or
Strip Fixture
Antenna Orientation On
Top of Fixture
Top of Fixture
Antenna
(must be
vertical for best range
and must extend out
of fixture for proper
operation)
and must extend out
of fixture for proper
operation)
Note: Please use template label to cut 5/8" hole for Antenna
5/8" hole in
fixture
needed for
Antenna
Emergency Ballast
Emergency Ballast
Wire Covers RMC-LP
Antenna
(must be
vertical for best range)
Top of Fixture
Note: Antenna is not removable
2