TP-Link Technologies Co. Ltd. TDW8961NDV3 Manuale Utente

 

 

24

¾  Connection: For PPPoA/PPPoE connection, you can select Always on or Connect 

on-Demand or Connect Manually. Connect on demand is dependent on the traffic. If there 

is no traffic (or Idle) for a pre-specified period of time), the connection will tear down 

automatically. And once there is traffic send or receive, the connection will be automatically 

on. 

¾  Static/Dynamic IP Address: For PPPoA/PPPoE connection, you need to specify the public 

IP address for this ADSL Router. The IP address can be either dynamically (via DHCP) or 

given IP address provided by your ISP. For Static IP, you need to specify the IP address, 

Subnet Mask and Gateway IP address. 

¾  Default Route: You should select Yes to configure the PVC as the default gateway to 

internet from this device. 

¾  MAC Spoofing: Enable the MAC Spoofing, and enter a MAC address to configure the WAN 

port. It makes your inside network appear as a device with this MAC address to the outside 

world. 

If you select this type of connection, the modem can be configured to act as a bridging device 

between your LAN and your ISP. Bridges are devices that enable two or more networks to 

communicate as if they are two segments of the same physical LAN.   

 

Figure 4-10 

) 

After you finish the Internet configuration, please click SAVE to make the settings take effect. 

Choose “Interface Setup

→LAN” menu, and you will see the LAN screen (shown in Figure 4-11). 

Please configure the parameters for LAN ports according to the descriptions below.