TP-Link Technologies Co. Ltd. TDW8961NDV3 Manuale Utente

 

 

25

 

 

Figure 4-11 

¾  Router Local IP: These are the IP settings of the LAN interface for the device. These 

settings may be referred to as Private settings. You may change the LAN IP address if 

needed. The LAN IP address is private to your internal network and cannot be seen on the 

Internet. 
• 

IP Address: Enter the Router’s local IP Address, then you can access to the Web-based 

Utility via the IP Address, the default value is 192.168.1.1. 

• 

IP Subnet Mask: Enter the Router’s Subnet Mask, the default value is 255.255.255.0. 

• 

Dynamic Route: Select this option to specify the RIP (Routing Information protocol) 

version for LAN interface, including RIP1, RIP2-B and RIP2-M. RIP2-B and RIP2-M are 

both sent in RIP2 format, the difference is that RIP2-M using Multicast, while RIP2-B 

using Broadcast format. 

• 

Direction: Select this option to specify the RIP direction. None is for disabling the RIP 

function.  Both means the ADSL Router will periodically send routing information and 

accept routing information, and then incorporate them into routing table. IN only means 

the ADSL router will only accept but will not send RIP packet. OUT only means the 

ADSL router will only send but will not accept RIP packet.