TP-Link Technologies Co. Ltd. WR1043NDV2 Manuale Utente

 

)

1.  The router can automatically locate new USB drive.   

2.  The new settings will not take effect until you restart the service.   

3.  To unplug the USB drive, click Eject Disk button first. It is not recommended to simply pull 

the USB drive out of the USB port, because this can cause damage to the device and cause 

data loss.   

4.  Mounted volumes are subject to the 8-volume limit, so you cannot access more than 8 

volumes on the USB storage device. 

Choose menu “USB Settings→FTP Server”, and then you can configure FTP Server on this 

page as shown in Figure 4-35. 

 

Figure 4-35 

FTP Server Configuration 

¾

 

Server Status - Indicates the FTP Server’s current status, started or stopped. You can click 

the Start button to start the FTP Server and click the Stop button to stop it.     

¾

 

Internet Access – Indicates the current status of Internet Access. Choose Enable to enable 

the Internet Access and choose Disable to disable it.   

¾

 

Service Port - The numbers of External Service Ports.   

¾

 

Internet address - Displays the WAN IP address of this router, so that others can access 

FTP through this address. If WAN type is PPPOE/PPTP/L2TP, there would be two 

connections. Therefore, users can access FTP Server via two connections. Users in a 

private LAN can access FTP Server via Public Address while internet users can access 

FTP Server via Internet Address. 

1.  Plug an external USB hard disk drive or USB flash drive into this router, and then the screen 

will appear as shown in Figure 4-36. 

-49-