TP-Link Technologies Co. Ltd. WR1043NDV2 Manuale Utente

 

 

Figure 4-59 Remote Management 

¾

 

Web Management Port - Web browser access normally uses the standard HTTP service 
port 80. This router's default remote management web port number is 80. For greater security, 
you can change the remote management web port to a custom port by entering that number 
in the box provided. Choose a number between 1 and 65534 but do not use the number of 
any common service port.   

¾

 

Remote Management IP Address - This is the current address you will use when accessing 
your router from the Internet. This function is disabled when the IP address is set to the 
default value of 0.0.0.0. To enable this function change 0.0.0.0 to a valid IP address. If set to 
255.255.255.255, then all the hosts can access the router from internet.   

)

1.  To access the router, you should type your router's WAN IP address into your browser's 

address (in IE) or Location (in Navigator) box, followed by a colon and the custom port 

number. For example, if your router's WAN address is 202.96.12.8, and the port number 

used is 8080, please enter http://202.96.12.8:8080 in your browser. Later, you may be 

asked for the router's password. After successfully entering the username and password, 

you will be able to access the router's web-based utility. 

2.  Be sure to change the router's default password to a very secure password. 

Choose menu “Parental Control”, and then you can configure the parental control in the screen 

as shown in Figure 4-60. The Parental Control function can be used to control the internet 

activities of the child, limit the child to access certain websites and restrict the time of surfing. 

-68-