TP-Link Technologies Co. Ltd. WR64XGV0 Manuale Utente

 

 31

¾

  Region - Select your region from the pull-down list. This field specifies the region where the 

wireless function of the router can be used. It may be illegal to use the wireless function of 

the router in a region other than one of those specified in this field. If your country or region 

is not listed, please contact your local government agency for assistance. 

The default region is United States. When you select your local region from the pull-down list, 

Click the Save button, then the Note Dialog appears. Click OK. 

 

) 

Some regions may not use 108Mbps Mode since the operation for the wireless interface in 

108Mbps Mode is illegal.  Limited by local law regulations, version for North America does not 

have region selection option. 

¾

  Channel - This field determines which operating frequency will be used. It is not necessary 

to change the wireless channel unless you notice interference problems with another nearby 

access point. 

¾

  Mode - Select the desired wireless mode. The options are:   

• 

Super G

™

, 802.11g and 802.11b wireless stations can connect 

to the router. 

• 

 Only Super G

™

 wireless stations can connect to the router. 

• 

 Both 802.11g and 802.11b wireless stations can connect to the 

router. 

• 

 Only 802.11b wireless stations can connect to the router. 

) 

The default is "54Mbps (802.11g)", which allows both 802.11g and 802.11b wireless stations to 

connect to the router. 

¾

  Enable Wireless Router Radio - The wireless radio of this Router can be enabled or 

disabled to allow wireless stations access. If enabled, wireless stations will be able to 

access the router. Otherwise, wireless stations will not be able to access. 

¾

  Enable SSID Broadcast - If you select the Enable SSID Broadcast checkbox, the Wireless 

Router SSID will broadcast its name (SSID) on the air. 

¾

  Enable Bridges - If you select Enable Bridges, you can communicate with the other APs in 

bridge mode by entering their MAC addresses. For example: If you want to communicate 

with the remote AP whose MAC address is 00-E0-4C-00-07-BE, please enter the MAC