AIR802 LLC AP25N01 Manuale Utente
AP25N01 User Manual
17
Station Parameters Settings
The options below are only available in Station, Station WDS and Repeater WDS
modes, unless otherwise stated.
modes, unless otherwise stated.
Remote AP-ESSID
This is the Service Set Identifier used by the station to seek and connect to the access
point of the same SSID identifier.
This is the Service Set Identifier used by the station to seek and connect to the access
point of the same SSID identifier.
Site Survey
Site Survey will search for the available wireless networks in range on all supported
channels and will allow you to select one for association. If the selected network uses
encryption, you also need to set security parameters in the wireless security section.
Click Scan to re-scan for all access points in range. Select the Access Point from the list
and click Close. The Site Survey channel scan list can be modified using the Channel
Scan List control.
Site Survey will search for the available wireless networks in range on all supported
channels and will allow you to select one for association. If the selected network uses
encryption, you also need to set security parameters in the wireless security section.
Click Scan to re-scan for all access points in range. Select the Access Point from the list
and click Close. The Site Survey channel scan list can be modified using the Channel
Scan List control.
Remote AP – Lock to MAC
Enter the MAC address of the remote access point the device is connected to. This
option will make the device only connect to this access point. This is important when the
connection is Point-to-Point operation.
option will make the device only connect to this access point. This is important when the
connection is Point-to-Point operation.
Remote AP - Preferred MAC
Enter the preferred MAC addresses of the access points you want the device to connect
to when it first starts up. Up to four MAC addresses can be entered. Priority is from top
to bottom. In the event that all preferred MAC addresses are not available, the device
will pick the matching SSID access point with the strongest signal.
to when it first starts up. Up to four MAC addresses can be entered. Priority is from top
to bottom. In the event that all preferred MAC addresses are not available, the device
will pick the matching SSID access point with the strongest signal.