ALLREMOTE Wireless Technology Co. Ltd. RRC065A Manuale Utente

4.) Press the button that used in step 2 on the RRC065A, The blue LED will light for 3

sec. then off. RRC065A will transmit 4 kind of frequency-390MHz, 318 MHz, 310

MHz, and 300 MHz, After receiving the signal (it takes about 1~5sec), the receiver will

activate. Since the RRC065A is releasing 4 different signal frequencies after

clicking the remote button once, the blue LED light might be still on even the garage

gate is moving. So if user wants to transmit again, user must wait till the blue LED

light absolutely off, then press the button.

GENIE’S Garage Door operation

1.) Following same way with RRC065A Duplication Mode, Duplicating Genie’s remote unit

code into RRC065A.

2.) Please Following Genie’s Original User Manual, and learning RRC065A as new group for

setting up

3.) Please be notified that each Genie receiver can only accept two individual RRC065A units

(other receivers can allow unlimited unites for duplicating). And same button on each unit

can not be used at the same time.

※ GENIE’S Main Receiver Learning Mode.

Press once learning button of Main receiver, the red LED indicator on the receiver will start

flashing, then move the RRC065A face toward to main receiver and press the button that

used for duplicating. When Main receiver catches the signal, the red LED on the receiver

will stop flashing but remain lighting on.

After seeing the receiver LED light changed to be on permanently, press the same button

on the RRC065A again, the red LED on the receiver will be turning off. And the whole

process is done.

(Note: In certain instances, this procedure may cause the Genie

Intellicod /GMI-3BL

Remote to "unlearn" the programming. Make sure to check the Genie

Intellicode /GMI-3BL

Remote when finished, and re-program according to the manufacturer's Instructions if

necessary. Then check both units to make sure that they operate the garage door opener

properly.)

Allremote Wireless Technology, 2008/4/7