Neptune Technology Group Inc. BELTCLIPT3 Manuale Utente
Updating R900 BCT Firmware
You cannot update multiple R900 BCTs at once; they must be updated
individually.
individually.
When there is an update to the R900 BCT firmware, it is available from Neptune through
the web updates in the R900 BCT software, or it can be obtained from Neptune Customer
Support through email or direct upload to an FTP site.
the web updates in the R900 BCT software, or it can be obtained from Neptune Customer
Support through email or direct upload to an FTP site.
With either choice for receiving the firmware update, the firmware is updated in the
N_SIGHT R900 database and then sent to the R900 BCT through the USB transfer cable
or saved to the SD card and installed on the R900 BCT.
N_SIGHT R900 database and then sent to the R900 BCT through the USB transfer cable
or saved to the SD card and installed on the R900 BCT.
To update the R900 BCT firmware update with the USB cable, the
R900 BCT must first be connected to the PC and be in Mass Storage
Mode. To update through the SD card, the Firmware Update File can be
transferred to the SD card by using an SD Card Reader.
R900 BCT must first be connected to the PC and be in Mass Storage
Mode. To update through the SD card, the Firmware Update File can be
transferred to the SD card by using an SD Card Reader.
To update the R900 BCT firmware, complete the following steps.
1. Connect the R900 BCT to the PC and place in Mass Storage Mode.
2. In the N_SIGHT R900 host software, select Utilities.
3. Select the Beltclip Firmware tab. See Figure 6.
Figure 6 – Tab within N_SIGHT R900 Utilities
16
R900 Belt Clip Transceiver User's Manual
Setting Up the R900 Belt Clip Transceiver