Xeline Co. LTd. MM-202BX Manuale Utente

 

12 

power cable.   

③ 

Connect the SU-200BX test unit to the MM-202BX UPLINK port using a RJ-45 cable. 

④ 

Connect the S U-200BX power cable to a power outlet from the same phase as the 

installed MM-202BX. 

⑤ 

Turn on the power of the MM-202BX. 

⑥ 

Using a long sharp instrument, push down on the reset button of the SU-200BX to. 

⑦ 

Turn on the power of the SU-200BX while the reset button is pushed down. 

⑧ 

Check if the ACT LED is blinking. 

⑨ 

Disconnect the RJ-45 cable from the SU-200BX and MM-202BX. 

⑩ 

Reconnect the MM-202BX cables to their original positions. 

⑪ 

Reset the power of the SU-200BX.   

⑫ 

Connect the laptop PC to the LAN port of the SU-200BX and configure the network 

properties. 

⑬ 

Confirm if the Internet connection is working properly.  

 

4.6 Resetting to Factory Default Mode 

Use the reset button at the top side of the MM-202BX in order to reset the configuration into 

factory default mode.   

① 

Turn off the power of the MM-202BX. 

② 

Disconnect all cables (including CU-100A cables) from the MM-202BX except for the 

power cable. 

③ 

Use a long sharp instrument (such as a tweezers) in order to push down on the reset 

button on the top side of the MM-202BX. 

④ 

Turn on the MM-202BX while pushing down on the reset button. 

⑤ 

Using the  sharp instrument, push  down on the reset button for 1 second.  Wait at 

least 1 second before repeating the procedure at least 3 times or more. 

⑥ 

The ACT 2 LED will blink when the MM-202BX is changed to the factory default mode. 

⑦ 

Reset the power of the MM-202BX.