Honeywell International Inc. WFSLCDUI Manuale Utente
14
PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0 10/10/2013
W-GATE
Mounting & Wiring
2.5 Mounting & Wiring
2.5.1 Mounting
The W-GATE has two major pieces, the cover and the mounting plate. The mounting plate is
mounted to the wall or ceiling, and field wiring is connected to it. The cover contains the PC board
and is fastened to the mounting plate once the wiring is connected.
mounted to the wall or ceiling, and field wiring is connected to it. The cover contains the PC board
and is fastened to the mounting plate once the wiring is connected.
Mount the mounting plate directly to an electrical box on the ceiling or wall. The plate mounts
directly to 4˝ square (with and without plaster ring), 4˝ octagon, 3 1/2˝octagon, single gang or dou-
ble gang junction boxes. If an electrical box is not available, the mounting plate can be mounted to
any flat surface and the wiring can be connected via the knockout points in the mounting plate.
directly to 4˝ square (with and without plaster ring), 4˝ octagon, 3 1/2˝octagon, single gang or dou-
ble gang junction boxes. If an electrical box is not available, the mounting plate can be mounted to
any flat surface and the wiring can be connected via the knockout points in the mounting plate.
To mount the W-GATE, do the following:
1.
Pull the wiring through the opening in the mounting plate.
2.
Mount the mounting plate to the junction box or ceiling. See figure 2.2.
3.
Connect field wiring to the terminals, as described in section 2.5.2, "Wiring".
4.
Connect necessary jumpers where applicable, as described in section 2.5.3, "W-GATE
Powered from SLC".
Powered from SLC".
5.
To mount the cover, align the locating pins on the cover to the corresponding slots in the
mounting plate. See Figure 2.3, "Cover Attaching to Mounting Plate".
mounting plate. See Figure 2.3, "Cover Attaching to Mounting Plate".
6.
Secure the cover by tightening the mounting screws.
Figure 2.2 Mounting Plate