Honeywell International Inc. WFSLCDUI Manuale Utente
PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0 10/10/2013
37
Agency Approvals
Wireless Display Driver (W-DIS-D)
•
Maximum Gateway
•
Maximum devices
Supervisory Event
•
Tamper
3.2 Agency Approvals
3.2.1 FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two con-
ditions:
ditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause
undesired operation.
undesired operation.
FCC ID PV3WFSLCDUI
WARNING: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE
MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
3.3 Specifications
W-DIS-D
The following are the specifications for the W-DIS-D device.
NOTE: All connections are power limited and supervised.
Specification
Data
Operating Voltage Range
18VDC to 30VDC
Maximum current draw
30 mA
ANN-BUS
Driver: 1.5V - 3.4V and 60 mA max.
Receiver: 0.2V - 6V
Receiver: 0.2V - 6V
Radio Frequency
Lower ISM band (915 MHz)
Maximum power output
+17 dBm
Minimum signal strength level needed at the
receiver for a primary path with weak link reporting
enabled
receiver for a primary path with weak link reporting
enabled
-63 dBm
Minimum signal strength level needed at the
receiver for a secondary path (minimum signal to
noise point) or a primary path with weak link trouble
reporting disabled
receiver for a secondary path (minimum signal to
noise point) or a primary path with weak link trouble
reporting disabled
Must be 15 dBm higher than the noise floor down
to -87dBm
to -87dBm
Table 3.1 W-DIS-D specifications