Honeywell International Inc. WFSLCDUI Manuale Utente

PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0 10/10/2013  

39

Wireless Display Driver (W-DIS-D)

The W-DIS-D has two major pieces, the cover and the mounting plate. The mounting plate is 
mounted to the wall or ceiling and field wiring is connected to it. The cover contains the PC board 
and is fastened to the mounting plate once the wiring is connected. 

Mount the mounting plate directly to an electrical box on the ceiling or wall. The plate mounts 
directly to 4˝ square (with and without plaster ring), 4˝ octagon, 3 1/2˝octagon, single gang or dou-
ble gang junction boxes. If an electrical box is not available, the mounting plate can be mounted to 
any flat surface and the wiring can be connected via the knockout points in the mounting plate. 

To mount the W-DIS-D, do the following:

1.

Pull the wiring through the opening in the mounting plate.

2.

Mount the mounting plate to the junction box or ceiling. See figure 3.2.

3.

Connect field wiring to the terminals, as described in 3.5.2, "Wiring".

4.

Connect necessary jumpers where applicable. Refer to section 2.5.3, "W-GATE Powered 
from SLC".

5.

To mount the cover, align the locating pins on the cover to the corresponding slots in the 
mounting plate. See Figure 3.3, “Cover Attaching to Mounting Plate” .

Secure the cover by tightening the mounting screws.