Honeywell International Inc. WFSLCDUI Manuale Utente
PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0 10/10/2013
41
Mounting & Wiring
Wireless Display Driver (W-DIS-D)
3.5.2 Wiring
•
All wiring must be installed in compliance with the National Electrical Code and the local
codes having jurisdiction.
codes having jurisdiction.
•
12-18 AWG is recommended.
Figure 3.4 Wiring Diagram with Terminal Descriptions
For wiring connections, follow this procedure:
•
Strip about 3/8” of insulation from the end of the wire.
•
Then, to make the wire connection, slide the bare end of the wire under the appropriate
clamping plate, and tighten the clamping plate screw.
clamping plate, and tighten the clamping plate screw.
3.5.3 ANN-80
Mounting
The ANN-80 has to be mounted next to the Fire Alarm Control Panel. For further instructions on
mounting and wiring of ANN-80, refer to ANN-80-series product installation document.
mounting and wiring of ANN-80, refer to ANN-80-series product installation document.
Wiring
Table 3.3 ANN-80 series to power source
ANN-80 Series Terminals (TB1)
ANN-BUS Terminals
Terminal 1 (-)
External power ground
Terminal 2 (+)
External power 24VDC
Terminal 3 (A)
A (ANN-BUS)
Terminal 4 (B)
B (ANN-BUS)