Honeywell International Inc. WFSLCDUI Manuale Utente

44

PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0  10/10/2013

Wireless Display Driver (W-DIS-D)

To remove a profile from a W-DIS-D without using the PC-based configuration tool, perform the 
following steps:

1.

Start with the device powered off. The process is performed during the start-up

2.

Power on the W-DIS-D using external +24V.  This can be done either by attaching the W-DIS-
D to its mounting plate with the terminals already energized, or by connecting the external 
source wiring to a W-DIS-D that is already installed in its mounting plate.

3.

Verify the W-DIS-D is in the profile modification state; if it is in the profile modification state, 
both the LEDs on the W-DIS-D flash yellow (double blink) every second for ten seconds.

4.

Activate both the magnetic sensors within ten seconds of starting up the W-DIS-D (while the 
double yellow blink is active in the W-DIS-D) or repeat step 1.

5.

The W-DIS-D LEDs blink green every second for five seconds indicating that the profile is 
removed.

NOTE: After following the above steps, the profile is erased and the device returns to factory 
default state. This is indicated by five green blinks every 0.5 seconds.

To restore a W-DIS-D to factory default state with the PC-based configuration tool, perform the fol-
lowing steps:

1.

To remove a profile in a device using the PC Tools application, do the following:

2.

Connect the W-USB dongle device to your computer.  For more information on USB dongle, 
refer to Section 5:, "USB Adapter".

3.

Launch the PC Tools application.  Refer to Appendix B:, "PC tools" to know about launching 
the PC Tools application.

4.

Go to Site Survey, Create Mesh Network or Diagnostics step.

5.

Click Extras and select Reset Devices. The Reset Devices screen appears, displaying the W-
DIS-D and other devices that have the profile assigned.

6.

Click to select the required device and click Reset Device to remove the profile.