Honeywell International Inc. WFSLCDUI Manuale Utente

PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0 10/10/2013  

65

Devices

To turn a distributor device back to a network device, replace the battery and provide a proper code 
wheel address. A normal device requires four batteries for trouble-free operation. It is recom-
mended to use fresh batteries after the distributor mode. 

To add a device to a mesh, refer to the topic, "Mesh Formation with PC Tools" or, to form a mesh 
network, ensure that the W-GATE is powered on and contains a profile.  Activate the mesh forma-
tion” (Figure 2.8, “Mesh Formation Magnetic Sensor on a W-GATE”) magnet sensor on the W-
GATE.



The Firelite Wireless Sensor Network does not require the use of a dedicated repeater; all wireless 
devices act as repeaters. When the repeater function is needed in a location where there is no spe-
cific fire function is required, a wireless monitor module or another device can be installed to fulfill 
the function as a repeater.

A device can be restored to factory default state by following the below steps.

1.

Start with the device powered off. The process is performed during the start-up.

2.

Power on the device by inserting a single battery into any slot in the device. The LEDs blink 
yellow twice every five seconds for one minute continuously after inserting the battery.

3.

Toggle the code wheel address pattern to 0-159-0.  To toggle the SLC code wheel address,

• Set the address to 0.

• Change the address to 159.

• Change the address back to 0.

NOTE: The above illustration depicts the rotary switches being set at address 35 (rotary switch 
on 'TENS' set at 3 and rotary switch on 'ONES’ set at 5. Ensure that the code wheel address 
pattern is toggled within 1 minute of inserting the battery. 

After the code wheel pattern is set, the LEDs in the device blink green five times followed by a sin-
gle or double red blink confirming that the device has been reverted back to factory default condi-
tion.