Boston Scientific Neuromodulation Corporation PSC5210W Manuale Utente
34
Physician Implant Manual
Charging Steps
WARNINGS:
• Do not charge while sleeping. This may result in a burn.
• While charging, the Charger may become warm. It should be
• While charging, the Charger may become warm. It should be
handled with care.
• Failure to use the Charger with either the Charging Belt or an
adhesive patch, as shown, may result in a burn. If pain or discom-
fort is felt, cease charging and contact Advanced Bionics.
fort is felt, cease charging and contact Advanced Bionics.
The Charger Base Station should be plugged in and the Charger
placed in the cradle until the indicator light is green. If the indicator is
amber-colored, the Charger may not be able to fully charge the Stimu-
lator.
placed in the cradle until the indicator light is green. If the indicator is
amber-colored, the Charger may not be able to fully charge the Stimu-
lator.
Users must wear the Charger over the Stimulator using the Charging
Belt or adhesive patches. Advanced Bionics recommends using the
Charging Belt for charging.
Belt or adhesive patches. Advanced Bionics recommends using the
Charging Belt for charging.
1. When the indicator light is green, remove the Charger from the
Base Station. (The indicator will go off, regardless of the ready
status of the Charger.)
status of the Charger.)
2. Using the Adhesive Patch:
Apply the adhesive patch to the
backside of the Charger by peeling
the clear liner from the patch and
applying the white side with the
blue stripe to the rear of the
Charger. Remove the skin side
beige liner. (See diagram below.)
backside of the Charger by peeling
the clear liner from the patch and
applying the white side with the
blue stripe to the rear of the
Charger. Remove the skin side
beige liner. (See diagram below.)
OR