Truth Hardware 4353 Manuale Utente
Programming the Remote Control
If optional Hand Held Remote was purchased, it can now be
programmed using the “Learn” button (see S1 on wire diagram)
Program the remote using the following steps:
Place three “AAA” batteries into the Remote.
The display on the Remote will be blank except for the word “SET”
programmed using the “Learn” button (see S1 on wire diagram)
Program the remote using the following steps:
Place three “AAA” batteries into the Remote.
The display on the Remote will be blank except for the word “SET”
Set
Unit
Mode
Open
Close
Press the “Learn” button (S1) on the control board once
Grey
Green
Grey
Grey
Grey
Green
Green
Green
Yellow
Yellow
Yellow
Grey
Grey
Grey
Red
Black
Blue
Blue
Blue
12
12
12
12
10
10
10
10
7777
5555
4444
S2
S2
S2
S2
S1
S1
S1
S1
1
2
3
4
5
6
on
off
J2
J2
J2
J2
Red
LED
LED
Status
LED
A red LED will flash… and the status LED (on control board or wall
plate) will begin to flash green.
“Learn”
button
button
“Set” icon
is displayed after
batteries are installed
is displayed after
batteries are installed