Kirisun Communications Co. Ltd. PT420801 Manuale Utente

                                                                               Page 18 of 22 

DTMF signaling, press corresponding programmable keys “Call 1” “Call2”, the codes can be 

transmitted.  

 

In the communication network, you can expand communication range through the repeater, but 

when the mobile radio is out of the communication range, you can connect with other radio in the 

talkaround method. 

Switch the talkaround or repeater mode through “Talkaround” key. 

 

The station can be programmed to scan multiple channels to receive signals from them. 

 

a) Press the key programmed to “Scan”, the Scan function is entered. During the scan, 

channels in the scan list of the phone will stop will signals are found, the phone will stay 

at the channel with signals till the signals disappear, if the time delay between the 

signals disappear and the scan resumes, the phone will stay at the current channel if no 

signal is received during the dime delay.   

b) Priority Scan:   

You can select one channel in the scan list as the priority channel, which has the highest 

priority during the scan, during the scan, a non-priority channel in the scan list will be 

scanned first, and then the priority channel, and then the next non-priority channel, and 

then the priority channel again, and the scan goes on in this cycle.   

If the priority channel and the flyback period are set in the Scan list, when the phone 

receives signals in a non-priority channel, it is in the Scan Stopped status and will fly 

back the priority channel in a certain cycle, if there are signals in the priority channel, it 

will stay at the priority channel, if there are no, it will return to the original channel.   

c) There are the following options for the back channel during the scan set by the dealer 

(i.e., the transmitting channel during the scan):   

Select the preset channel: The phone transmits signals from the channel where the scan 

is started.