ZTE Corporation ZTEC88 Manuale Utente

Set up Your Phone

This chapter outlines the steps required to set up your phone, power-on and activate on your service provider’s

network.  Follow the procedure below step-by-step to get started.

Battery

Please switch off your phone and disconnect the charger with it before remove the battery.  Avoid touching electronic

components on the battery and battery compartment of the phone.

Installing the Battery

1.

Insert battery to the plastic retainer clip.  Make sure the + and – terminals on the battery be lined up with the

metallic points in the battery compartment.

2.

Push down on the bottom section of the battery until it clicks into place.  It should be aligned with the bottom of

the phone.

3.

Place the battery cover so that it covers the entire battery.  Slide the cover until it locks into position.  Make sure

the battery cover is secure.

Charging the Battery

Your phone is powered by a rechargeable battery.  The battery is not fully charged when you purchase your phone, but

there may be enough power in the battery to turn the phone on.  Charge the battery with the procedure indicated below.

Note:  For maximum battery performance, it is recommended that you completely charge the battery before using

the phone for the first time.  A new battery’s full performance is achieved only after three complete charge and

discharge cycles.

1.

Pull the rubber USB cover out of the USB port and rotate it 90 degrees.

2.

Insert the charger’s USB adapter into the USB port.  Ensure that the adapter is inserted with the correct

orientation.  Do not force the connector into the USB port.

Note: Make sure plug the AC charger into a standard AC outlet box when you begin charging the battery.