ZTE Corporation ZXMBW-E9230 Manuale Utente
ZXMBW E9230 User Manual
Note:
The grounding cable length that connects the ZXMBW E9230
cabinet with the grounding copper bar should be less than 2
m.
cabinet with the grounding copper bar should be less than 2
m.
2. Connect the copper lug at the end of grounding cable to the
grounding screw of ZXMBW E9230 cabinet. Screw down the
grounding screw.
grounding screw.
3. The cooper bar of ground net is as shown in
. Clear
off rust on the copper bar and then connect the other end of
grounding cable to the copper bar. Finally, fix them with a bolt.
grounding cable to the copper bar. Finally, fix them with a bolt.
F
IGURE
44 C
OPPER
B
AR OF
G
ROUND
N
ET
4. Cover antirust lacquer around the bolt.
5. Affix a label on the grounding cable.
E
ND OF STEPS
Installing RF Jumper
Context
RF jumper is used to connect the main feeder and the antenna
feeder interface of ZXMBW E9230. Its installation is supposed to
be after that of the main feeder.
feeder interface of ZXMBW E9230. Its installation is supposed to
be after that of the main feeder.
The RF jumper adopts the finished 1/2″ jumper with 2 m long. It
can also be made at fieldwork according to the practical condition.
can also be made at fieldwork according to the practical condition.
shows the installation position of RF jumper.
50
Confidential and Proprietary Information of ZTE CORPORATION