Linx Technologies 3F090003X Manuale Utente

RK-Wi.232DTS-FCC Rapid Development Kit 

User’s Manual

 

 

The RK-Wi.232DTS-FCC-FCC is a rapid-development/evaluation kit FCC pre-certified module, the FCC-
Wi232DTS.  When used within the guidelines presented in this document, no FCC part 15 
testing/certification of the FCC-Wi232DTS is necessary in the end product. 

Included in the kit is: 

•  1-Rapid Development Case. 
•  1-Rapid Development Utility and Documentation CD. 
•  2-Wi.232DTS Rapid Development Boards. 
•  2-FCC-Wi.232DTS pinned modules. 
•  2-900 MHz antennas. 
•  2-RS-232 cables. 
•  2-USB cables. 
•  6-AAA batteries. 
•  Startup Guide. 

 

2  RApid Development Kit Setup 

•  Insert the AAA batteries into the evaluation PCB, observing the correct polarity. 
•  Insert an FCC-Wi.232DTS module into one of the evaluation boards, observing the correct 

orientation (see later in this document). The correct orientation of the module is with the antenna 
connector closest to the edge of the evaluation board. Make sure it is seated fully and correctly. 

•  Insert the other FCC-Wi.232DTS module into the other evaluation board, also observing the 

correct polarity. 

•  Connect antennas to FCC-Wi.232DTS modules. 
•  Connect evaluation boards to computers. If using USB communications, populate USB jumpers 

and remove RS-232 jumpers. If using RS-232 communications, populate RS-232 jumpers and 
remove USB jumpers.  

•  Install the RK-Wi.232DTS-FCC Windows software. If already installed, skip this step. 
•  Run the RK-Wi.232DTS-FCC software, select 2400 baud operation and navigate to the “Wireless 

Chat” tab. 

•  Power-On both evaluation boards, verifying that the version/copyright information is echoed to the 

screen from both modules. 

•  Chat back and forth between evaluation boards, verifying that serial and RF communications are 

successful. 

• 

: See section 4.1 

 

© 2002-5 Radiotronix Inc, all rights reserved

  - 3 - 

11/7/2005