Linx Technologies 3F090003X Manuale Utente
RK-Wi.232DTS-FCC Rapid Development Kit
User’s Manual
3.3 Non-Volatile Register Page.
The Non-Volatile Register
page in the evaluation
software allows you to
change the default
settings which will be
loaded when the module
is powered on.
It is important to note that
data rates in excess of
19.2kbps cannot be
achieved in LP mode due
to bandwidth limitations.
page in the evaluation
software allows you to
change the default
settings which will be
loaded when the module
is powered on.
It is important to note that
data rates in excess of
19.2kbps cannot be
achieved in LP mode due
to bandwidth limitations.
Tip: If you change the
Non-Volatile Data Rate
setting, you will have to
select the baud rate you
set this register to when
you start the RK-
Wi.232DTS-FCC
evaluation software.
Non-Volatile Data Rate
setting, you will have to
select the baud rate you
set this register to when
you start the RK-
Wi.232DTS-FCC
evaluation software.
3.4 Volatile Register Page
In this page, you can
change the Volatile
settings of the module.
Values programmed into
these registers are lost of
power-down.
change the Volatile
settings of the module.
Values programmed into
these registers are lost of
power-down.
The page also provides a
means of switching the
receiver and transmitter
on and off, setting receive
and transmit channels,
transceiver mode and
modulation settings.
It is important to note that
data rates in excess of
19.2kbps cannot be
achieved in LP mode due
to bandwidth limitations.
means of switching the
receiver and transmitter
on and off, setting receive
and transmit channels,
transceiver mode and
modulation settings.
It is important to note that
data rates in excess of
19.2kbps cannot be
achieved in LP mode due
to bandwidth limitations.
© 2002-5 Radiotronix Inc, all rights reserved
- 5 -
11/7/2005