Hewlett Packard Enterprise Company MSR4000DFS Manuale Utente
20
Aruba MSR4000 Wireless Mesh Router
| Installation Guide
Second Wrapping of Tape
1. Cut a 4” (100 mm) strip of electrical tape from the roll.
2. Using 3/4” (19mm) electrical tape, begin wrapping at the connector and create four layers.
3. After completing the fourth layer of tape, check your work to ensure there are no places where water
can collect. If there are, you must smooth out those areas with additional layers of tape or remove the
weatherproofing and begin again.
weatherproofing and begin again.
Figure 17 Completed Wrapping
4. Repeat this process for all connectors.
Installing the MSR4000
The MSR4000 can be installed on a wall or attached to a pole. Pole diameter must be 40 to 60 mm at the
position where the MSR4000 will be mounted. The following section describes how to attach the necessary
hardware to the router and how to mount the router in the selected location.
position where the MSR4000 will be mounted. The following section describes how to attach the necessary
hardware to the router and how to mount the router in the selected location.
Mounting Assembly
The mounting assembly for installing MSR4000 includes the following as shown in
and
Solar Shield
Mounting bracket
Pole anchors x 2
Bolts
First and third layers wrap
top to bottom
AP175_20
Pieces of tape as needed
Rubber will be wrapped
with 4 layers of tape
Second and final layers wrap
bottom to top