Hewlett Packard Enterprise Company MSR4000DFS Manual Do Utilizador

| Installation Guide

1. Cut a 4” (100 mm) strip of electrical tape from the roll.

2. Using 3/4” (19mm) electrical tape, begin wrapping at the connector and create four layers.

3. After completing the fourth layer of tape, check your work to ensure there are no places where water 

can collect. If there are, you must smooth out those areas with additional layers of tape or remove the 
weatherproofing and begin again. 

Figure 17  Completed Wrapping

4. Repeat this process for all connectors.

The MSR4000 can be installed on a wall or attached to a pole. Pole diameter must be 40 to 60 mm at the 
position where the MSR4000 will be mounted. The following section describes how to attach the necessary 
hardware to the router and how to mount the router in the selected location.

The mounting assembly for installing MSR4000 includes the following as shown in 

 and 



Solar Shield



Mounting bracket



Pole anchors x 2



Bolts

First and third layers wrap

top to bottom

Pieces of tape as needed

Rubber will be wrapped

with 4 layers of tape

Second and final layers wrap

bottom to top