Controlled Electronic Management Systems Ltd S610MSCRM Manuale Utente
S610S Manual - Hardware Installer Manual - Version 1.8
15
Note: Other inputs, including lock status can be fitted with a resistor network in the same
way.
way.
Enable 4-state tamper detect
Use the workstation AC2000 Devices application. From the table, select the device the sensor is
connected to.
Under
connected to.
Under
Configuration
select the
Inputs
tab. Select
Each Input
that needs to be configured for 4 state
from the list and check
4 state
.
3.7 Using an external read head
In some exceptional circumstances it may be necessary to connect an external read head to the
reader for dual technology access. For example a barcode reader can be connected to H0 to allow
access to barcode type cards, as well as Prox card holders.
reader for dual technology access. For example a barcode reader can be connected to H0 to allow
access to barcode type cards, as well as Prox card holders.
To connect an external read head to the secure side of a door use H0 head connection found on
the reader PCB. H0 pin order is shown below; the reader wires are for a sample only.
the reader PCB. H0 pin order is shown below; the reader wires are for a sample only.
To connect a read head for an Exit reader use H1. See connecting an Exit Reader later in this
manual.
manual.
3.8 S610S Lock and spare output relay connections
The S610E reader has two volt-free changeover relays.
The following S610S parameters may be changed using the Devices application if required: -
lockopentime (sec)
- maximum time to open the door after a valid card presentation
doorcloseafter (sec)
- maximum time for door to remain open before an alarm is generated
Connecting a lock
In normal door mode Relay 0, the first relay, is reserved for a door lock. A door lock controlled
by Relay 0 does not require any AC2000 workstation software configuration; unless changes to
the default five second
by Relay 0 does not require any AC2000 workstation software configuration; unless changes to
the default five second
Lock open time
is necessary. Relay 1, the second relay, (if not used for
Interlocking) is spare and can be used to activate an external device e.g. sounder or strobe light.
Connect a maglock or a lock that is secure when electrically energised to the relay output
connector J12 as follows:
connector J12 as follows:
Relay Connector J12 showing typical Maglock configuration.
HEAD0-12V
RED0
GREEN0
AMBER0
HEAD GND
WIEGO-D1
WIEGO-D0
5volts
READ HEAD
READ HEAD
H0
LABEL
WHT- DATA1/CLOCK
GRN - DATA0/DATA
BLK - GND
ORN - GREEN LED
BRN - RED LED
RED - 5.0 - 16.0 VDC
J2