Redline Communications Inc. AN80IC Manuale Utente
Red
CONNEX
™
User
AN-80i
Manual
70-00072-01-05-DRAFT
Proprietary Redline Communications © 2008
Page 27 of 94
January 22, 2008
Telnet Enable: Check this box
to enable a Telnet access (CLI) to the AN-80i. Refer to
the CLI commands in CLI Interface on page 62.
Telnet Port: Enter Telnet port address (default is 23).
SNMP Enable: Check this box
to enable the Simple Network Management Protocol
(SNMP) agent. When this item is checked, click on the blue text
[
Configure
SNMP
]
adjacent to the check box to display the SNMP Configuration screen.
Mgmt. Tag Enable: Check
this box to enable VLAN tagged traffic.
The Mgmt Tag Enable setting is disabled (factory default) when shipped from the factory
or following a long-reset operation. In this mode the PTP Master and PTP Slave can be
managed through the local Ethernet port using untagged traffic. Over-the-air management
is possible only after creating a pass-through group and pass-through connections for
each PTP Slave.
When Mgmt Tag Enable is enabled, this PTP Master or PTP Slave can be managed only
using VLAN traffic tagged with the value specified in the Mgmt. VID field. Over-the-air
management is possible only after creating a VLAN tagged group and VLAN tagged
connections for each PTP Slave.
It is recommended to create and test a VLAN group for tagged management traffic before
activating the Mgmt Tag Enable function. Set the associated QoS and priority values to
ensure management traffic has adequate priority and bandwidth during system operation.
or following a long-reset operation. In this mode the PTP Master and PTP Slave can be
managed through the local Ethernet port using untagged traffic. Over-the-air management
is possible only after creating a pass-through group and pass-through connections for
each PTP Slave.
When Mgmt Tag Enable is enabled, this PTP Master or PTP Slave can be managed only
using VLAN traffic tagged with the value specified in the Mgmt. VID field. Over-the-air
management is possible only after creating a VLAN tagged group and VLAN tagged
connections for each PTP Slave.
It is recommended to create and test a VLAN group for tagged management traffic before
activating the Mgmt Tag Enable function. Set the associated QoS and priority values to
ensure management traffic has adequate priority and bandwidth during system operation.
Mgmt. VID: Enter the VLAN ID. When Mgmt. Tag Enable is selected, the system
recognizes only management commands with this VLAN ID.
recognizes only management commands with this VLAN ID.
Important: The VLAN network support should be verified before enabling this feature
to ensure the AN-80i system will be reachable using the VLAN tagged traffic.
to ensure the AN-80i system will be reachable using the VLAN tagged traffic.