Redline Communications Inc. REM2500M Manuale Utente
User
REM Outdoor Subscriber
Manual
70-00121-01-00
Proprietary Redline Communications © 2009
Page 22 of 34
October 20, 2009
Table 12: CLI - interface - Ethernet and Wireless Configuration Commands
Set Authorization Policy mode.
0 - Disabled: No authentication.
1 - Enabled: Authentication is required.
openloopsupport <0 | 1>
Subscriber terminal adjusts transmission level based on the signal strength
openloopsupport <0 | 1>
Subscriber terminal adjusts transmission level based on the signal strength
measured on the preamble received from the base station.
0 - Disabled: Subscriber does not use open loop control.
1 - Enabled: Open loop control is active.
csublayer <0-2>
View and modify the wireless interface convergence sublayer settings.
View and modify the wireless interface convergence sublayer settings.
0 - IPCS+NAT
1 - EthernetCS
2 - IPCS
phy <bandwidth> <framesize >
View and modify the wireless interface physical layer settings.
bandwidth <5000 | 7000 | 8750 | 10000>
Channel size (Hz).
Channel size (Hz).
5000
- 5 MHZ
7000
- 7 MHZ*
8750
- 8.75 MHZ*
10000 - 10 MHZ
framesize <5000 | 10000>
Frame duration (microseconds).
framesize <5000 | 10000>
Frame duration (microseconds).
5000
- 5,000 us
10000 - 10,000 us
Show <configCapabilities> <csublayer> <phy>
Display the wireless configuration.
For example:
For example:
CPE(itf:wman0)# show phy
Settings -- <<SS Mmgt PHY Configuration Parameter>>
Bandwidth= 7000 kHz
FftSize=
Bandwidth= 7000 kHz
FftSize=
1024
CyclicPrefix=
8 PS
FrameSize=
5000 us
Note: The bandwidth setting controls the FFT size and cyclic prefix.
* Not supported by 1.8 GHz CPE.