Redline Communications Inc. REM2500M Manuale Utente
User
REM Outdoor Subscriber
Manual
70-00121-01-00
Proprietary Redline Communications © 2009
Page 23 of 34
October 20, 2009
4.3.6 loadImage - Download and Activate Software Image
Use the loadImage command to update the subscriber over-the-air or using the local
Ethernet connection. The following items must be addressed before beginning software
upgrades:
1.
All software upgrades use an FTP server.
2.
The FTP server must have a user account with the following settings:
Username
:
target
Password
:
secret
3.
The subscriber binary file must be copied to the default file location for this user
account on the FTP server.
Table 13: CLI - loadImage - Upgrade CPE Software Commands
loadImage
Load new subscriber software image. This command does not accept any parameters. The
command will prompt for the following information:
ServerIP
IP address of FTP server.
Filename
Filename
Name of the binary file. Must be located in the FTP default directory.
Example:
CPE#> loadImage
Server IP Address: 192.168.100.100
File Name: REM-18-M-001-02-02-005.bin
Opening FTP connection.....Done
Downloading image
..
Server IP Address: 192.168.100.100
File Name: REM-18-M-001-02-02-005.bin
Opening FTP connection.....Done
Downloading image
..
..........................................................................................………………
Done
Programming update........Done
Erasing setup partition. Done.
Writing setup partition. Done.
Erasing boot block. Done
Programming boot block. Done
Flash programming complete.
CPE#><enter reboot command to load new software>
Programming update........Done
Erasing setup partition. Done.
Writing setup partition. Done.
Erasing boot block. Done
Programming boot block. Done
Flash programming complete.
CPE#><enter reboot command to load new software>
4.3.7 realm - Domain Reference for Locating AAA Server
May be used by the ASN to select the AAA server.
Table 14: CLI - realm - For Locating AAA Server Commands
realm <set> <show>
Set parameters to factory default values. If no parameter is specified.
Set parameters to factory default values. If no parameter is specified.
configuration
<backup> <restore>
Use an FTP server to save and restore the subscriber configuration.
set <domain.name>
Enter a new realm domain.
Enter a new realm domain.
Example:
CPE# realm tier1.com
CPE# realm tier1.com
show
Display current realm.
Display current realm.