PointRed Telecom Ltd. MCRD-2458 Manuale Utente
M i c r o R e d & M i c r o V i e w N M S U s e r M a n u a l v 1 . 0
Page 131
11. System Services
MicroRed can be configured to run the following services:
x
SNMP (Simple Network Management Protocol) Service
x
HTTP (Hyper-Text Transfer Protocol) Service
x
SSH (Secure Shell Protocol) Service
x
NTP (Network Time Protocol) Service
To configure System Services settings, select the Services tab, located under the
Advanced Configuration of Node, Configuration tabs.
Advanced Configuration of Node, Configuration tabs.
Figure 134. Services Tab
11.1.
Configuring SNMP Settings
SNMP (Simple Network Management Protocol) is the most widely used protocol
for managing TCP/IP Internets. A network management station (NMS) uses
SNMP query (poll) SNMP processes (agents) on network devices such as routers
and end stations. These agents maintain a list of variables and their values that
describe the state of the network device. The variables can describe routing table
entries, interface addresses, and byte counts transmitted on various interfaces.
The collection of variables is described by a Management Information Base
(MIB).
for managing TCP/IP Internets. A network management station (NMS) uses
SNMP query (poll) SNMP processes (agents) on network devices such as routers
and end stations. These agents maintain a list of variables and their values that
describe the state of the network device. The variables can describe routing table
entries, interface addresses, and byte counts transmitted on various interfaces.
The collection of variables is described by a Management Information Base
(MIB).
When SNMP is enabled, MicroRed will respond to SNMP requests (SNMP get,
getnext, getbulk, walk).
getnext, getbulk, walk).