Advanced Control Technologies Inc. 0797-01 Manuale Utente
Evolve LRM-AS Series 300, Rel. 5.1 Instructions
LRM-AS
by Evolve Guest Controls
EvolveNet Radio Frequency (RF) Controlled, 500W, 120 VAC,
Wall Mounted Dimmer, Series 300, Release 5.1
LRM-AS WALL Mounted diMMeR
The LRM-AS Wall Mounted Dimmer is a component of the HomePro lighting control system. Wire the Wall
Mounted Dimmer in place of the standard wall switch according to the diagram above and program from the
Wireless Controller to operate loads. Inclusion of the LRM-AS Wall Mounted Dimmer on the EHC-100 Wireless
Controller menu allows remote ON/OFF control and dimming of lights connected.
This Wall Mounted Dimmer is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other
types can be Included in the network and will also act as repeaters to increase the range of the network.
Mounted Dimmer in place of the standard wall switch according to the diagram above and program from the
Wireless Controller to operate loads. Inclusion of the LRM-AS Wall Mounted Dimmer on the EHC-100 Wireless
Controller menu allows remote ON/OFF control and dimming of lights connected.
This Wall Mounted Dimmer is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other
types can be Included in the network and will also act as repeaters to increase the range of the network.
this product is scene capable.
This product supports 40Kbps data transmission. This product can also be used for networking support in
systems that stream metadata. An example might include transmission of information from audio devices such
as song title, artist, and album information to various displays around the home.
systems that stream metadata. An example might include transmission of information from audio devices such
as song title, artist, and album information to various displays around the home.
dAnGeR! Shock hAzARd. Read and understand these instructions before installing. This device is
intended for installation in accordance with the National Electric code and local regulations in the United States,
or the Canadian Electrical Code and local regulations in Canada. It is recommended that a qualified electrician
perform this installation. There are no field repairable assemblies on this unit. If service is needed, the unit must
be returned where purchased.
cAution: to reduce the risk of overheating and possible damage to other equipment, do not install
to control a receptacle, a motor operated appliance, a fluorescent lighting fixture, or a transformer-supplied
appliance, but only permanently installed incandescent lamp fixtures. Make sure the lamp(s) to be controlled
directly from the dimmer receiver total no more than 500 watts. Do not install this device if there is not at least
10 meters (30 feet) or more of wire between the point of connection and the electrical service panel. Retain
intended for installation in accordance with the National Electric code and local regulations in the United States,
or the Canadian Electrical Code and local regulations in Canada. It is recommended that a qualified electrician
perform this installation. There are no field repairable assemblies on this unit. If service is needed, the unit must
be returned where purchased.
cAution: to reduce the risk of overheating and possible damage to other equipment, do not install
to control a receptacle, a motor operated appliance, a fluorescent lighting fixture, or a transformer-supplied
appliance, but only permanently installed incandescent lamp fixtures. Make sure the lamp(s) to be controlled
directly from the dimmer receiver total no more than 500 watts. Do not install this device if there is not at least
10 meters (30 feet) or more of wire between the point of connection and the electrical service panel. Retain
Supplied with matching decorative
switch plate
note:
This module must be “Included in the Network”
only where it will be permanently installed.
The
proper operation of this node in the mesh network is
dependent on it knowing its location with respect to other
nodes. You cannot “test bench” configure this module.
dependent on it knowing its location with respect to other
nodes. You cannot “test bench” configure this module.
LRM-AS
• This product supports Zensor Net Beam technology.