Falcom GmbH BOLERO-LT Manuale Utente
BOLERO-LT Hardware Description
Version 1.0.0
8 APPENDIX
8.1 Schematics
The figure below illustrates a common schematic when you use the BOLERO-LT
hardware for vehicle security. For detailed information, please, refer to the
related documents [
hardware for vehicle security. For detailed information, please, refer to the
related documents [
].
8.1.1 Installation guidance for 6-pin connector
On the top-right of the schematic you can find the corresponding pin out of the
6-pin connector.
6-pin connector.
1 x Power supply (+IN)
: Connect to the vehicle battery (clamp 30).
1 x Ignition line (IGN) :
Connect to the vehicle starter lock (clamp 15)
and use it for triggering alarms whenever the
vehicle ignition key is closed (engine started). Or
connect it to the operating voltage (+IN) to use
the IGN-Sleep mode (see also Fig. 10.1)
The schematic below represents how these lines can be use
d.
The operating voltage range MUST never be exceeded. For security reason, it is
recommended to integrate externally a 2A fuse link between the positive wire of
the BOLERO-LT (+IN) and d.c. - power source.
the BOLERO-LT (+IN) and d.c. - power source.
Please note that, the ground pin of the BOLERO-LT should be isolated from
the vehicle body to avoid ground loops.
Figure 15:
Schematic example of installation guidance
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 30