Vivato Inc. VLJ24WFSW Manuale Utente

State: Enable or Disable the interface.

IP Address: Enter the IP address for that interface. 

Netmask: Enter the subnet mask for that interface. 

After editing settings, select Make Changes to put the changes into effect.

Unlike previous wireless LAN broadcasting, Vivato’s Wi-Fi Switch uses a focused antenna pattern 
to point precisely at the desired client device. These narrow patterns of Wi-Fi enable up to three 
simultaneous Wi-Fi transmissions on three channels pointed in different directions. These narrow 
patterns also reduce co-channel interference, since they are powered only when needed.

The Wi-Fi Switch contains 13 signal processing wireless interfaces (wlan1 to wlan13) that can be 
individually configured or configured in groups to direct the antenna pattern. Each wireless interface 
transmits and receives signals within a specific area of the Wi-Fi Switch’s pattern (see 

). To provide simultaneous operation on 

two or three channels, the same ESSID is typically used for each wireless interface and the channel 
setting for each interface is configured as shown in 

Important Under most circumstances, the default channel assignments shown below should be used, 

especially when using the Wi-Fi Switch in areas of heavy Wi-Fi traffic. Channel 6 can be used 
to provide three channel operation (along with channels 1 and 11) when Wi-Fi traffic is light.